Stop c00002la fatal system error windows logon

This is also called a repair install. It basically replaces all your system files, but keeps all your data and applications. You will have to reinstall all Windows updates after perform a repair. You can read our previous post on how to perform a repair install scroll to the bottom of the post. A lot of times the Winlogon. You can check to see if the original file has been replaced by a third-party one by going to the following registry key:.

If they key does not exist at all, then the system is using the default Msgina. If there is a third-party file being used, you need to remove or disable the third party software. Usually, this is done by remote control software, so if you have any remote control programs installed, remove those. If you are getting this message right after installing the latest Windows updates, you can try to uninstall them using the recovery console.

Hopefully one of these solutions will solve your problem! Founder of The Back Room Tech and managing editor. What I mean is sometimes i can boot my computer, sometimes i cannot and it shows the error message above. However, even if i can boot my computer, it will shut down automatically after a couple of minutes. In reply to Student's post on August 27, That is curious to me if it boots at all with that error, but if it does boot sometimes, then I reckon you should see if you can get the minidumps to zigzagx.

Rotsa ruck! Hi zigzagx Thanks for your reply. To my surprise, no DMP files has been created for this problem. However, please note that this is not related to the current problem. Thanks you for your help. Best regards, Student Hi ElderL Thanks for your reply.

The computer can be boot in safe mode. However, to my surprise, no minidump files have been saved for this problem. I have seen at least 5 such error message today and i am very sure i have configure the computer to save copies of minidumps files. Now I found the source of the problem. These may be if the DLLs were recently changed. I created the list of the DLLs linked to the Winlogon. It was the large list. I made the new installation of the Windows XP to the same disk to the Windows.

After that I checked the sizes and versions of the DLLs from my computer. I found that 3 difference: Gdi Windows started successfully! The Dr. Watson debugger program logs all information related to failed processes to the Drwtsn In addition to this, the debugger program can be configured to create memory dump files related to the failed processes.

You can refer these dump files to analyze the reason behind a process failure. Perform the following steps to configure Dr. Watson as the default debugger program to record user-mode program errors: Open Start menu, select Run, type Drwtsn This command sets Dr. Watson as the default debugger.

Next, run the Drwtsn In the Dr. Watson command. Here, view the paths to the Dr. Watson and User. Open Windows Explorer, navigate to the log files and then open them. Most of the time, this error occurs due to the failure of the Winlogon.