Set windows nic to promiscuous mode

Data: 1. Data 1 will enable the mode. On Linux: You can use ifconfig as in the following example. To put the NIC in promiscuous mode: [root] ifconfig eth0 promisc. To remove the NIC from promiscuous mode: [root] ifconfig eth0 -promisc.

Stack Overflow for Teams — Collaborate and share knowledge with a private group. Create a free Team What is Teams? Learn more. Ask Question. Asked 3 years, 6 months ago. Active 3 years, 6 months ago. Viewed 2k times. Network Adapters are based on Intel X using latest driver. Improve this question. TimB TimB 1 1 silver badge 10 10 bronze badges. Work with your instructor or Skytap administrator to edit these settings. The VM Settings page displays.

The Network Adapters tab is selected by default. Notes Promiscuous mode should not be confused with port mirroring or span ports, where a network switch can send a copy of all traffic in a particular network to a particular port on another network.

Network adapters with promiscuous mode can't accept unicast traffic intended for other VMs or traffic between other VMs within the same network. Because Skytap sends traffic only to network adapters that actively use a specific MAC address, promiscuous mode doesn't allow passive observation of network traffic. Notes Promiscuous mode can only be enabled once per VM per network. As long as that is checked, which is Wireshark's default, Wireshark will put the adapter into promiscuous mode for you when you start capturing.

If the adapter was not already in promiscuous mode, then Wireshark will switch it back when you stop capturing. This should be the same, regardless of whether Wireshark is installed on Windows 7 or Windows Jim Aragon 7. Glad to hear that. So I don't understand why I can't see traffic on the HUB that isn't directly communicating with the Wireshark computer.

Please see my previous question about intercepting packets between two remote computers.